1995 Camry WIPER MOTOR CIRCUIT BREAKER INSPECTION PROCEDURE

download
INSPECTION PROCEDURE: Inspect the Wiper Fuse. Verify there is power and ground to the Wiper Motor on all speeds (including “Intermittent” or “Mist” if applicable). After verifying power and ground to the Wiper Motor, follow the procedure below to prevent unnecessary Wiper Motor replacement because of a temporary open in the Wiper Motor Circuit Breaker. 1) Disconnect the Wiper Motor Harness Connector. 2) Wait (10) minutes before checking continuity. 3) Check the continuity of the motor with an ohmmeter. REPRESENTATIVE CHECKING PROCEDURE: NOTE: Continuity check can be performed between either the low speed or high speed terminal and the ground terminal of the wiper motor. The standard resistance of a good wiper motor is approximately 1.5 to 4.5 ohm

Incoming search terms:

• Kawasaki Fe 290 Engine Specs
• Screaming Eagle 103 Motor Review
• ultma motor breakin instructions
• crf 50 top end exploded view
• FE290 Engine Specs
• kawasaki fe290 horsepower boost
• location of stator ss 113 motor
• how to remove side motor on a 1995 suzuki intruder
• kawasaki FE290 timing
• fe 290 engine specs